Page 1:Rosewill Capstone-G1200 Power Supply Review
Page 2:Packaging, Contents, Exterior And Cabling
Page 3:A Look Inside And Component Analysis
Page 4:Load Regulation, Hold-Up Time And Inrush Current
Page 5:Efficiency, Temperature And Noise
Page 6:Cross-Load Tests And Infrared Images
Page 7:Transient Response Tests
Page 8:Ripple Measurements
Page 9:Performance, Performance Per Dollar, Noise and Efficiency Ratings
Page 10:Pros, Cons And Final Verdict
Transient Response Tests
Advanced Transient Response Tests
For details on our transient response testing, please click here.
In these tests, we monitored the response of the PSU in two different scenarios. First, a transient load (10A at +12V, 5A at 5V, 5A at 3.3V and 0.5A at 5VSB) was applied for 200ms while the PSU was working at 20 percent of its capacity. In the second scenario, the PSU was hit by the same transient load while operating at 50 percent of its capacity. In both tests, we used our oscilloscope to measure the voltage drops caused by the transient load. The voltages should have remained within the ATX specification's regulation limits.
These tests are crucial because they simulate the transient loads a PSU is likely to handle (such as booting a RAID array or an instant 100 percent load from a gaming platform). We call these "Advanced Transient Response Tests," and they are designed to be tough to master, especially for PSUs with less than 500W of capacity.
Advanced Transient Response at 20 Percent
Advanced Transient Response at 50 Percent
The +12V rail's performance is very good in these tests; we were also satisfied by the performance of the 5V and 5VSB rails. As usual, the 3.3V rail registered higher deviations. However, in both cases it managed to stay above 3.2V, so we aren't complaining.
Here are the oscilloscope screenshots we took during Advanced Transient Response Testing:
Transient Response At 20 Percent Load
Transient Response At 50 Percent Load
Turn-On Transient Tests
In the next set of tests, we measured the response of the PSU in simpler transient load scenarios—during the PSU's power-on phase.
For the first measurement, we turned off the PSU, dialed in the maximum current the 5VSB could output and switched the PSU on. In the second test, we dialed the maximum load the +12V could handle and started the PSU while it was in standby mode. In the last test, while the PSU was completely switched off (we cut off the power or switched off the PSU by flipping its on/off switch), we dialed the maximum load the +12V rail could handle before switching on the PSU from the loader and restoring the power. The ATX specification states that recorded spikes on all rails should not exceed 10 percent of their nominal values (+10 percent for 12V is 13.2V, and 5.5V for 5V).
Our scope caught a small spike at 5VSB, though it's nothing to worry about. In the second test, we didn't see any spikes or voltage overshoots. All of that changed during the last test though, where ripple suppression briefly went out of control. More than likely, this has to do with the ACRF topology. We must stress that even short periods of increased ripple can apply huge stress to system components.
- Rosewill Capstone-G1200 Power Supply Review
- Packaging, Contents, Exterior And Cabling
- A Look Inside And Component Analysis
- Load Regulation, Hold-Up Time And Inrush Current
- Efficiency, Temperature And Noise
- Cross-Load Tests And Infrared Images
- Transient Response Tests
- Ripple Measurements
- Performance, Performance Per Dollar, Noise and Efficiency Ratings
- Pros, Cons And Final Verdict