Noctua NH-U14S TR4-SP3 Review: Silent Threadripper Overclocking

Like its smaller sibling, the NH-U12S TR4-SP3, the Noctua NH-U14S TR4-SP3 provides whisper-quiet cooling with big league thermal performance – the kind of overclocked Threadripper performance that sneaks into quality 360 all-in-one cooling performance. Armed with six nickel-plated copper heatpipes and a NF-A15 140mm PWM fan, the AMD-friendly NH-U14S TR4-SP3 is a silent thermal assassin. For Threadripper air cooling, this cooler checks all the boxes for enthusiasts and overclockers alike.



6.75 inches / 171.45mm


5.96 inches / 151.4mm


2.1 inches / 52.3mm

(3.14 inches / 79.8mm w/fan)

Base Height

1 inch / 25.1mm

Assy. Offset

0.0 inches (centered)
1.1 inches / 27.94mm (w/fans)
Adjustable -3mm, -6mm

Cooling Fans

(1) 140 x 25mm


(1) 4-pin PWM


36.5 oz / 1035g

Intel Sockets

AMD Sockets

TR4, SP3


6 years

Like all Threadripper-specific coolers, Noctua ships the NH-U14S TR4-SP3 with minimal hardware and accessories. Additional fan clips and anti-vibration mounts allow for a second cooling fan to be added for push+pull configuration, while the included tube of NT-H1 thermal compound means you won't need to make a run for paste to complete installation. 

A speed-reducing cable allows for even quieter operation, and the included long, L-shaped, hex-key wrench allows for torquing down those installation bolts. Noctua even has the bling department covered with an enamel painted, metal, adhesive case badge. How’s that for attention to detail?

The six copper heatpipes of the NH-U14S TR4-SP3 are nickel-plated for an aesthetically pleasing, chrome-like finish, while the mounting base and hardware receive the same nickel treatment. The large, 140mm NF-A15 PWM (pulse width modulation, for controlling fans) cooling fan provides the required cooling airflow while sporting the signature Noctua cream and reddish-brown color scheme. Wire spring clips loop through the fan mounting holes and snap over the cooling fin side cutouts to secure the fan to the cooling tower.

The contact base of the NH-U14S TR4-SP3 consists of a precision milled copper block and is plated with nickel. The surface is nearly mirror smooth and provides a full contact surface for Threadripper CPUs. The nickel-plated copper heatpipes nestle into the cooling base and extend through the cooling tower fins. Due to Threadripper and Epyc socket exclusivity, spring tension mounting bolts are integrated into the mounting base hardware.

The NH-U14S TR4-SP3 uses the same adjustable mounting base for GPU configuration offset in the same manner as its NH-U12S TR4-SP3 sibling does. The included hex-key is used for adjustment from 0mm to 3mm and 6mm offsets. Check your specific cooler fitment and perform these offset adjustments prior to the final mounting of the cooler itself – you’ll be happy you did.

With a slim cooler design, the installation and final torque down of the mounting bolts was quite simple. Fan interference with normal height memory DIMMs was relatively minimal, although the fan can be installed slightly higher on the cooling tower with the wire snap clips, if needed. Due to the greater overall height of the NH-U14S TR4-SP3, carefully consider the available clearance inside your case.

MORE: Best CPU Cooling

MORE: How To Choose A CPU Cooler

MORE: All Cooling Content

Create a new thread in the UK Article comments forum about this subject
This thread is closed for comments
No comments yet
Comment from the forums
    Your comment