Did you spend some time this week wondering what Nvidia was planning for today's announcement? Everyone who guessed GeForce GTX 690, you're right. Powered by two GK104 graphics processors, we have the scoop on Nvidia's soon-to-be flagship.
I had my head so thoroughly buried in the Ivy Bridge launch that I completely missed Nvidia’s “Something is Coming” tease last week.
Well, now we know that “Something” is actually the company’s GeForce GTX 690. It’s not here yet; you’ll have to wait until next week for a comprehensive look at the card and its performance. But we do have all of the speeds and feeds thanks to tonight’s webcast from the Nvidia's GeForce LAN 2012 in Shanghai, China.
Inside of GeForce GTX 690
GeForce GTX 690 is a dual GK104 part. Its GPUs aren’t neutered in any way, so you end up with 3072 cumulative CUDA cores (1536 * 2), 256 combined texture units (128 * 2), and 64 full-color ROPs (32 * 2).
Gone is the NF200 bridge that previously linked GF110 GPUs on Nvidia’s GeForce GTX 590. That component was limited to PCI Express 2.0, and these new graphics processors beg for a third-gen-capable connection. Rather than engineering its own solution, though, Nvidia looked to PLX for one of its PEX 874x switches. The PCIe 3.0-capable switches accommodate 48 lanes (that’s 16 from each GPU and 16 to the bus interface) and operate at low latencies (down to 126 ns). What of NF200’s features incorporated to augment the performance of multi-GPU applications, Broadcast and PW Short? According to Nvidia, those capabilities were wrapped up into the PCIe 3.0 specification, so GeForce GTX 680 gets them through the PLX component.
Each graphics processor has its own aggregate 256-bit memory bus, on which Nvidia drops 2 GB of GDDR5 memory. The company says it’s using the same 6 GT/s memory found on its GeForce GTX 680, able to push more than 192 GB/s of bandwidth per graphics processor. Core clocks on the GK104s drop just a little, though, from a 1006 MHz base down to 915 MHz. Setting a lower guaranteed ceiling is a concession needed to duck in under a 300 W TDP. However, in cases where that power limit isn’t being hit, Nvidia rates GPU Boost up to 1019 MHz—just slightly lower than a GeForce GTX 680’s 1058 MHz spec.
Power is actually an important part of the GeForce GTX 690’s story. Nvidia’s GeForce GTX 590 bore a maximum board power of 365 W. One 75 W slot and two 150 W eight-pin plugs pushed the 590 mighty close to its ceiling. But because the Kepler architecture takes such a profound step forward in efficiency, Nvidia is able to tag its GTX 690 with a 300 W TDP. And yet it still includes two eight-pin inputs able to deliver up to 375 W, including the slot.
Consequently, representatives are claiming that there’s significant headroom to push the GeForce GTX 690 beyond the performance of twin GeForce GTX 680s. At its stock power and clock settings, though, we’re expecting it to be a little slower than two single-GPU boards on their own. The good news is that one GeForce GTX 690 should use markedly less power and operate more quietly than a pair of GTX 680s in SLI. Nvidia says it is deliberately binning low-leakage parts to minimize heat, and its own measurements put a GeForce GTX 690 at 47 dB(A) under load compared to 51 dB(A) for the 680s.