Page 2:Packaging, Contents, Exterior And Cabling
Page 3:A Look Inside And Component Analysis
Page 4:Load Regulation, Hold-Up Time And Inrush Current
Page 5:Efficiency, Temperature And Noise
Page 6:Cross-Load Tests And Infrared Images
Page 7:Transient Response Tests
Page 8:Ripple Measurements
Page 9:Performance, Performance Per Dollar, Noise and Efficiency Ratings
Page 10:Pros, Cons And Final Verdict
Load Regulation, Hold-Up Time And Inrush Current
To learn more about our PSU tests and methodology, please check out How We Test Power Supply Units.
Primary Rails And 5VSB Load Regulation
Load Regulation testing is detailed here.
Our hold-up time tests are described in detail here.
The hold-up time is pretty long, while the power-good signal drops before the rails go out of spec (as it should). Everything is find here, and obviously the 390uF bulk cap is more than enough for this PSU's needs.
For details on our inrush current testing, please click here.
The inrush current is low with 115V and close to normal levels with 230V input.
Load Regulation And Efficiency Measurements
The first set of tests reveals the stability of the voltage rails and the PSU's efficiency. The applied load equals (approximately) 10 to 110 percent of the maximum load the supply can handle, in increments of 10 percentage points.
We conducted two additional tests. During the first, we stressed the two minor rails (5V and 3.3V) with a high load, while the load at +12V was only 0.10A. This test reveals whether a PSU is Haswell-ready or not. In the second test, we determined the maximum load the +12V rail could handle with minimal load on the minor rails.
|Test #||12V||5V||3.3V||5VSB||DC/AC (Watts)||Efficiency||Fan Speed (RPM)||Noise (dB[A])||Temps (In/Out)||PF/AC Volts|
Load regulation is very tight on the +12V rail. It's good on the others as well, with 5V and 5VSB achieving 1.21% and 1.41% respectively, and the 3.3V rail a little higher with 1.76% deviation. In addition, the SF450 easily meets the 80 PLUS Gold requirements at 50% output and full load. It's only 0.1% off in the 20% load test, though we benchmark in a much hotter ambient environment than the 80 PLUS organization. It's common knowledge that a PSU's efficiency is significantly affected by high operating temperatures, and this accounts for the difference.
Up to the 50% load test, the fan's noise stays below 30 dB(A). Again, we had to push the small PSU hard to make its fan spin fast enough to exceed 40 dB(A). Under normal conditions, the fan profile is relaxed so you won't have to worry about excess noise. On the next page, you will find a graph that illustrates the fan's noise under normal conditions.
- Packaging, Contents, Exterior And Cabling
- A Look Inside And Component Analysis
- Load Regulation, Hold-Up Time And Inrush Current
- Efficiency, Temperature And Noise
- Cross-Load Tests And Infrared Images
- Transient Response Tests
- Ripple Measurements
- Performance, Performance Per Dollar, Noise and Efficiency Ratings
- Pros, Cons And Final Verdict