Page 2:Packaging, Contents, Exterior And Cabling
Page 3:A Look Inside And Component Analysis
Page 4:Load Regulation, Hold-Up Time And Inrush Current
Page 5:Efficiency, Temperature And Noise
Page 6:Cross-Load Tests And Infrared Images
Page 7:Transient Response Tests
Page 8:Ripple Measurements
Page 9:Performance, Performance Per Dollar, Noise and Efficiency Ratings
Page 10:Pros, Cons And Final Verdict
A Look Inside And Component Analysis
Before proceeding with this page, we strongly encourage you to a look at our PSUs 101 article, which provides valuable information about PSUs and their operation, allowing you to better understand the components we're about to discuss. Our main tools for disassembling PSUs are a Thermaltronics soldering and rework station, and a Hakko 808 desoldering gun.
|Transient Filter||4x Y caps, 2x X caps, 3x CM chokes, 1x MOV|
|Inrush Protection||NTC Thermistor & Relay|
|Bridge Rectifier(s)||1x GBU1508 (600V, 15A @ 115 °C)|
|APFC MOSFETs||1x Alpha & Omega AOK42S60 (700V, 25A @ 100 °C, 0.099 ohm)|
|APFC Boost Diode||1x CREE C3D04060A (600V, 6A @ 135 °C)|
|Hold-up Cap(s)||1x Nippon Chemi-Con (420V, 390uF, 2000h @ 105 °C, KMW)|
|Main Switchers||2x Fairchild FCP104N60F (600V, 24A @ 100 °C, 104 mhm)|
|APFC Controller||Champion CM6500UNX & CM03X Green PFC controller|
|Switching Controller||Champion CM6901|
|Topology||Primary side: Half-Bridge & LLC Resonant Converter|
Secondary side: Synchronous Rectification & DC-DC converters
|+12V MOSFETs||4x Alpha & Omega AON6590 (40V, 100A @ 100 °C, 1.55 mohm @ 125 °C)|
|5V & 3.3V||DC-DC Converters: 4x Infineon BSZ040N04LS G (40V, 40A @ 100 °C, 4 mohm)|
PWM Controller: APW7159
|Filtering Capacitors||Electrolytics: 1x Nippon Chemi-Con (1000h @ 105 °C, KMG), Rubycon (105 °C)|
Polymers: Nippon Chemi-Con
|Supervisor IC||SITI PS229 (OVP, UVP, OCP, PG) & AS358M|
|Fan Model||Corsair NR092L (92mm, 12V, 0.22A, 3950 RPM, Rifle Bearing)|
|Rectifier||1x APS04N60H FET (620V, 2.2A @ 100 °C)|
2x SVM1045V (45V, 10A @ 25 °C)
|Standby PWM Controller||Leadtrend LD7750RGR|
The new SF units are made by Great Wall, a manufacturer that also builds Corsair's CS line. This OEM has proven that it can build good PSUs, and that's exactly the case here. Inside the SF450, we find high-quality components and a modern design. There's an LLC resonant converter on the primary side and synchronous rectification on the secondary side, where the FETs that regulate the +12V rail are installed on the solder side of the mainboard and cooled by the chassis. There is one large heat sink on the primary side that looks beefy enough to support this unit's semi-passive mode. As you might expect from a compact PSU, the double-sided PCB is densely populated with components.
The AC receptacle is installed on a small PCB that also hosts the first part of the EMI filter, including two Y caps, a single X one and a CM choke. As usual, the second part of this filter is hosted on the main PCB and consists of two Y and a single X caps, two CM chokes and an MOV. The EMI filter is complete.
Right under the PFC input capacitor, responsible for filtering the high-frequency ripple that the bridge rectifier creates, is an electromagnetic relay used to bypass the NTC thermistor. This component provides protection against large inrush currents. The thermistor is located between the relay and the primary heat sink.
The single bridge rectifier is a GBU1508, able to handle up to 15A of current.
The APFC converter uses a single Alpha & Omega AOK42S60 FET and a CREE C3D04060A boost diode. The bulk cap is provided by Chemi-Con (420V, 390uF, 2000h @ 105 °C, KMW), and it has enough capacity to offer a hold-up time that easily meets ATX spec's requirements.
The APFC controller is a Champion CM6500UNX, which is also supported by a CM03X Green PFC controller. Both ICs are installed on the mainboard's solder side.
A couple of Fairchild FCP104N60F FETs are the primary switchers, arranged into a half-bridge topology (popular in high-efficiency PSUs). An LLC resonant converter is also used to boost efficiency through lossless switching. The resonant (and PWM) controller is a Champion CM6901, installed on the solder side of the mainboard along with a Si8233BD isolated driver. This driver is used by the main switching FETs, and it supports switching frequencies of up to 8MHz.
The +12V rail is regulated by four Alpha & Omega AON6590 FETs, which are clearly overkill for a 450W PSU since each one can handle up to 100A at 100 °C. The filtering of this rail is done mostly by high-quality Chemi-Con polymer caps. Besides a tiny Chemi-Con KMG electrolytic cap we also find three Rubycon ones. At least one of these Rubycons is used by the 5VSB circuit.
The minor rails are generated by a couple of DC-DC converters fed by the +12V rail. Each converter uses two Infineon BSZ040N04LS G FETs and the common PWM controller is an ANPEC APW7159. Again, Chemi-Con polymer caps are used for filtering these rails.
On the front side of the modular board, many polymer caps filter the PSU's outputs. Around back, a number of SMD components are installed.
We're impressed by the soldering quality. Many interesting components are installed on this side. In addition to the ones we just mentioned, we also find the supervisor IC, a SITI PS229, which is supported by a AS358M op-amp. There are actually two AS358Ms, though only one of them is likely utilized by the unit's protection features.
Corsair uses a 92mm rifle-bearing fan in both of its SF-series PSUs. The NR092L promises quiet operation even at higher speeds, thanks to its blades that purportedly increase airflow while keeping noise output as low as possible. The fan is supported by a semi-passive mode and a very relaxed ramp profile. We had to push the PSU hard to get its fan spinning at high speeds.
- Packaging, Contents, Exterior And Cabling
- A Look Inside And Component Analysis
- Load Regulation, Hold-Up Time And Inrush Current
- Efficiency, Temperature And Noise
- Cross-Load Tests And Infrared Images
- Transient Response Tests
- Ripple Measurements
- Performance, Performance Per Dollar, Noise and Efficiency Ratings
- Pros, Cons And Final Verdict