Sign in with
Sign up | Sign in

Faster USB 3.0 Performance: Examining UASP And Turbo Mode

Faster USB 3.0 Performance: Examining UASP And Turbo Mode
By

Why is it that an interface that operates at 5 Gb/s never reaches corresponding transfer rates? Our investigation reveals that not all USB 3.0-based solutions are created equal, and we explore two technologies used to bolster the performance of USB 3.0.

Most days, we treasure the utility, convenience, and instant connectivity of USB. But sometimes we curse the interface's very existence. USB's plug and play nature makes it incredibly easy to use. Sometimes, though, it almost malevolently refuses to recognize an attached device or transfer data at the speed we expect.

With Intel's 7-series chipsets and AMD's Fusion Controller Hubs now featuring native USB 3.0 support, it is difficult to imagine how we ever tolerated the first generation of USB more than a decade ago. With a maximum throughput of 1.5 MB/s, file transfers over USB 1.1 were frustratingly slow, though that was at least partially mitigated by the small-capacity memory sticks available back then.

Fast-forward a few years to the introduction of USB 2.0, which hit the market with an advertised maximum bandwidth of 60 MB/s—an enormous leap over USB 1.1. Saddled with protocol overhead and 8b/10b signaling, however, USB 2.0 was actually capped somewhere in the 30-40 MB/s range. That was good enough for a while. But we get desensitized to great performance, so, as affordable external RAID enclosures and SATA-based SSDs became more popular, it became painfully obvious that USB 2.0 was holding us up.

Enter USB 3.0, fulfilling our demand for a faster data interface with a blistering maximum throughput of 625 MB/s. After factoring in signaling, you're looking at a 500 MB/s ceiling. Even then, though, real-world performance never seems to get as high as those overly optimistic bandwidth charts so prominently featured by motherboard vendors on the front of their boxes.

Based on the performance of the thumb drives and external hard drives lying around our SoCal lab, we were worried that we weren't getting anywhere near the interface's potential. So, we set out to explore the state of USB 3.0 and figure out if there was any way to improve our USB 3.0 transfer speeds.

Ask a Category Expert

Create a new thread in the UK Article comments forum about this subject

Example: Notebook, Android, SSD hard drive

Display 3 comments.
This thread is closed for comments
  • 0 Hide
    AndrewJacksonZA , 20 June 2012 18:55
    Thank you for the informative article Andrew.
  • 0 Hide
    talos_2002 , 22 June 2012 14:33
    There is a mistake at page 5.
    The 4th picture shows a Syba SD-PEX20112 card with Asmedia controller, but below the picture you typed and linked to a SD-PEX20122 card with VLI controller.
  • 0 Hide
    Anonymous , 24 June 2012 02:47
    what abt SATAIII based flash drives then????