Conclusion

Ad

ATI NvidiaOur overclocking tests ended on some fairly positive results. Our GeForce and Radeon cards both played ball, and we were able to increase speed by approximately 20% on each GPU. That’s almost like moving up to the next card in the series! All without doing any very complex or very risky manipulations, and without spending one additional cent. We trust we’ve convinced you that overclocking a graphics card is worthwhile.

If you develop a taste for graphic overclocking, you’ll soon find out that we’re a long way from having covered all the territory. The Web and its forums are full of advice from much more adventurous users who aren’t afraid to try some much hairier overclocking. We’re talking about modifications to the cooling system, changing voltages by soldering additional resistors in the right places on the card and using pens with conductive ink (hard vmod). Those are the kinds of approaches that are being used to go far beyond the limits we’ve stayed within here.

For example, numerous Radeon HD 3870s have been pushed beyond a gigahertz, which is a really extreme GPU clock speed. All these complex modifications are described in numerous tutorials on numerous specialized forums. We’ll let the more fearless among you venture into that territory if you want to.

Finally, note that while we’ve focused only on overclocking, the utilities and BIOS editors we’ve used can also lower your card’s frequencies in order to limit power consumption, heating and noise when all your GPU’s firepower isn’t needed. After all, you can be a fan of high performance and still care about the environment!


Talkback
mi1ez 25/04/2008 02:52
Hide
-0+
mi1ez

A very insightful article. May have to experiment pushing my 3850 a bit further!

David345 25/04/2008 03:32
Hide
-0+
David345

I havent read all of the article so forgive me if it already answers this questtion but what would be better overclocking a graphics card yourself or buying one factory overclocked?. Also couldn't there have been a list of the overclockability of some graphics cards

spudd91 26/04/2008 10:35
Hide
-0+
spudd91

Will overclocking in BIOS overclock all cards in case of SLI mode?

Solitaire 30/04/2008 06:33
Hide
-0+
Solitaire

Funny, my 3850 could be pushed to 820MHz GPU within Catalyst's Overdrive page, not 730MHz. And Overdrive's Auto-Tune is very, VERY optimistic too - it pushed my stock-voltage 3850 to 775MHz core. Worked in SupCom:FA for three whole minutes! XD

mi1ez: Be careful, many 3850s have bad overheat issues under OC, and mistakenly pumping up the voltage will make that situation worse. I found out the hard way... With boosted voltage a 3850 can reach crazy speeds... if you decided to use watercooling, that is...

David345: Manufacturer-OC will yield lower speeds than DIY while costing a whole lot more. But the cards are usually much more stable and if you don't mess with them then its not your problem if the card gets borked. DIY saves (money)... unless you bork the card, in which case, good luck. You'll need it... :o

sdack 01/05/2008 04:06
Hide
-0+
sdack

David345 :
I havent read all of the article so forgive me if it already answers this questtion but what would be better overclocking a graphics card yourself or buying one factory overclocked?. Also couldn't there have been a list of the overclockability of some graphics cards


Of course, getting hardware that is already overclocked by the manufacturer is better. It however costs you considerably more money, too. Money which you could have invested into a completely different graphics card perhaps.

I personally avoid manufacturers who overclock hardware since I like to overclock it myself. If you then buy a card from a manufacturer that sells overclocked as well as standard hardware you will get only a little gain out of their standard offerings simply because they ones with a high gain got sorted out. Therefore best for overclocking is hardware that is being sold only as standard without an option of getting an overclocked version. These provide a better chance for a high gain and cost only little.

reho1990 18/08/2008 02:04
Hide
-0+
reho1990

hi i tryed it out yesteday but got a error on gpu-z when i go to save the bios it says (bios reading not supported on this device) i would really like to put it in to the bios but i need that saved file any ideas

Note You are going to post a comment as anonymous.



Google Ads