New Memory: DDR2-533, Continued

07:00 - Saturday 19 June 2004 by Patrick Schmid
Source: Tom's Hardware – Keywords: intel, stakes, its, vision, of, the, pc, future, with, 775, launch

Table of content:

New Memory: DDR2-533, Continued

Ad

Basically DDR2 memory works similarly to DDR1 and operates with two data transfers per clock cycle (double data rate mode). However, DDR2 has been designed to reach much higher clock speeds. New features make an appearance here: On-die termination takes care of signal reflection, and reduced page sizes lower the energy required for activating pages. Posted CAS makes it possible to carry out a CAS command directly after the RAS signal without any collisions. This simplifies the design of the controller and increases the theoretical load that the memory can handle. At eight cycle bursts, the specification provides for a new burst type called Sequential Nibble, which divides the burst into two 4 bit Nibbles. Also, this enables burst lengths of eight cycles in interleaving mode.

The package type that memory manufacturers prefer will either be FBGA (fine-line ball grid array) or tiny BGA. As there is nothing new to tell in terms of performance, the following table should provide sufficient information.

Memory Type Clock Speed Name Bandwidth
Single-Channel
Bandwidth
Dual-Channel
DDR266 133 MHz DDR PC2100 2,100 MB/s 4,200 MB/s
DDR333 166 MHz DDR PC2700 2,700 MB/s 5,400 MB/s
DDR400 200 MHz DDR PC3200 3,200 MB/s 6,400 MB/s
DDR2-400 200 MHz DDR PC2 3200 3,200 MB/s 6,400 MB/s
DDR2-533 266 MHz DDR PC2 4300 4,266 MB/s 8,533 MB/s
DDR2-667 333 MHz DDR PC2 5300 5,333 MB/s 10,666 MB/s
DDR2-800 400 MHz DDR PC2 6400 6,400 MB/s 12,800 MB/s

Source: Micron DesignLine Vol. 12, 3Q03

Talkback
Be the first to comment on this review!

Note You are going to post a comment as anonymous.



Google Ads