black screen after changing resolution

Hi,

My 15" AOC monitor went black after I increased the screen resolution. (The screen immediately went black.)

I restarted -- I can hear the winxp startup tune, but the screen remained black.

I've tried safe mode and "use last good configuration" but the same thing happens -- I hear the windows tune but the monitor stays black.

What should I do? Is there a way to lower the resolution via BIOS? or DOS?




P.S. would it work if I bought a 17" monitor?

Today a friend had the same problem. This solution will work if you have 'only a single row of tabs' across the top of the 'Properties' window. It also helps if you have fairly normal desktop settings.

You have to be viewing the desktop when you use this procedure. If any programs are open that are blocking the desktop you will have to close them from memory or force a re-boot. When the the Desktop is ready.

::::::::::::::::

move the mouse so it is way, way down in the lower right corner. Place a penny or dime on the mousepad touching the upper left corner of the mouse. Pull the mouse diagonally down to the right a distance equal to the diameter of the coin. Then back up to the coin.

Right Click

Take your hand off the mouse because the rest is on the keyboard.

up <arrow>

<Enter>

hold <Shift> press <Tab>

right <Arrow> 10 times.

<Tab>

left <arrow> (decreases resolution, right arrow to increase)

<Enter>


By the by if you can find a monitor that will accept the resolution you selected on the 'Properties' window you can switch it back the normal way.

mIKEY

This post has made me register. You don't have to go through all this. The easiest way to do it is to restart and while restarting hold F8 and in the startup menu choose vga mode. In there you can get the resolution back to normal. After that just restart normally and that's it.

Hope it helps.

i had this same problem and i went into VGA mode (press F8 right before the windows splash screen shows up & you may have to do it multiple times like i did). then , chose "VGA MODE"

.

After I changed the resolution in VGA mode i tried mikey's steps but one of them didn't work so i did this :
turn on computer (tower)


Wait Until you hear the windows startup theme
Take your hand off the mouse because the rest is on the keyboard.

up <arrow>

<Enter>

hold <Shift> press <Tab>

right <Arrow> 4 times.

<Tab>

left arrow to decrease & right to increase

<Enter>

...

i had to press the right arrow 4 times. I have a Samsung HDTV being used as a monitor and windows XP