Hello again, I have just a small question. I recently purchased a 212 Evo. I am looking for an additional fan to add to it for a push pull setup. Any recommendations from anyone else who owned one? Also, how much degrees did your temps drop after adding the second fan?
Generally there will not be any significant temputure drop by adding an extra fan for push pull. At most you might drop 2°c, but i wouldn't expect much. Ive ran push pull multiple times on both my Prolimatech Megahalems as well as my current Corsair H70 and i can say that the second fan creates little to no differance.
Lol is this your new saying!
I believe you! but i've yet to read a review on them from a any legit site i value/trust.
Personally i'd just match up the stock fan when it's available .
And ya you'll only get a 1-2C temp decrease.
Message edited by davcon on 02-07-2012 at 06:06:58 AM
Yate Loon fans are good and inexpensive. They push a decent amount of air and are also pretty quiet especially if you use a resistor to restrict the volt to 7v. I use them exclusively.
Fans from Nexus are also very good, but a little more expensive. In fact, Nexus cherry picks Yate Loon fans; the take the quietest ones that rolls off the conveyor belt.
------------------------------Q9450 |Corsair XMS 4GB DDR 800 | ABit IP35 Pro | HD 5850 | Audigy 2 | Seasonic S12 550 | Cooler Master Centurion 532 | NEC LCD2690WUXi and Planar PX2611w | WinXP
Peace on Earth by means of the destruction of all life on Earth. Reply to jaguarskx
What size fan do I need and how do I know if it's compatible with the Evo?
The Evo uses 120mm fans.
Here's the exact match which last time i checked is only available from CM.
I think that will change soon and most e-tailers will stock them in the future.