[Solved] Asus P8P67 LE Memory sticks rock in slot

Hello,
I know this mobo has been discussed a thousand times and you might be as sick of it as I am however I think I have found a problem that might also be an answer for memory issues and would like to hear your view/advice/opinion on it.

As my heading says, my memory which is Corsair 1600 XMS x2 = 8GB rocks in the memory slots about 1mm~2mm you can hear them click

I been having memory issues where the computer would just lock up and all you would see on screen is the last thing it was doing but you could not get it back from that state e.g. ctrl alt del etc

It went back to the shop with mem and cpu an i5 2500K but they couldn't find a problem with it. It later went back again to supposedly the supplier but they couldn't find a fault and suggested it was a cpu pin out of place (yeah pull the other leg.. talk about being insulted) anyway I brought it back home and on the first boot up I could make it fail by rocking the memory chips. It seems they don't sit completely home no matter how you try.

Should the memory stick rock in their sockets? ( I know they shouldn't but I would like your input)
Is that reason enough to get the board replaced?
One other question should I be able to use either set of memory slots as one set is blue which I am using and the other two are black which the compute will not work with them in.
I read in a previous post where this board had shorted memory slots.


Thanks in advanced.

This is a gif image that shows the rocking.. view it in a browser for the gif to work.

It is not going to fit in whatever way, it is not in the middle, that ridge : )

Hi Nikor

thanks for the input.
I have made sure it is in the correct way. I believe the locking mechanism is not working correctly. It is hard to see but the lock undoes just slightly when the chip is pressed at one end. This can cause chip creep which is why I think the computer is freezing up.

Will post close up of both sides of mem later today AU time.

Video removed due to OP request.

Hi Nikor,

Thanks again for the assistance I should have explained that I have been building computers for over 25 years including servers of all types so I do have a handle on memory.

What I was trying to find out, is there anyone out there that has a P8P67 LE ver X.XX and had a problem with the computer freezing where the screen continues to display the last image just before the freeze. I have read countless message like this but no one had an answer. I am suggesting it is because the memory sockets on the mobo are faulty, as they don't lock the memory in place correctly.

If they have had this problem then it could be memory that "creeps:moves only slightly" in the memory slots as the system goes from hot to cold or vise versa.

The reason that the memory can creep in this case is that the memory sockets are not locking the memory in properly.
The ends of the memory where the lock system is, moves slightly and to demonstrate that I applied some pressure to one end of a stick of memory which will cause it to fail. This will not happen on other mobos as the memory will not move because the memory locks don't allow any memory movement e.g. doesn't allow it to rock. The other way this could happen is when the environment/inside the computer case changes temperature.

Further example why your computer could Freeze while in the middle of use.

Note two things in this photo
1. The Memory socket is not soldered to the motherboard and leaves a change in height. This will affect memory functionality and reliability
2. Looking at the right hand side of the picture which is the end of this bank of memory slots note how the first slot is off the motherboard as mentioned earlier and that the next blue slot is actually on an angle! Poor quality control most likely due to the rush to get the updated Sandybridge boards out.



Added image separately to help see the memory sockets clearly

Best answer selected by lateralnw.

This topic has been closed by Nikorr