[Solved] Need to convert USB 3.0 20 pin header cable from front panel on a case to standa

Thank you for the reply! I have a Gigabyte GA-870A-USB3 mobo which you're right [NOW I looked at it] more pins for USB 3.0 than 2.0. The mobo also does not have a USB header interface [20 pin] connector on it. It does have just the USB 3.0 outside on the I/O panel though.

Just that this is a new project, and I hate to buy a case which requires the USB 3.0 cable to come out from the back, and plug into the external interface.

Fustrating... LOL!

I know ASRock makes a mobo with that internal 20 Pin USB 3.0 connector, and may have to go with this:
http://www.newegg.com/Product/Prod [...] 45tarel07m

Does anyone know of a mobo that offers Sata 6.0, up to 1800MHz bus [16GB Ram], AM3 chipset & supports CrossFire?

I think USB 3.0 is just to new for now. Thanks again CompulsiveBuilder.

Thank you Hoho1234! That will do it.

Unfortunately, I purchase the following case which has one USB 3.0 interface going to a USB 3.0 interface plug which gets plugged to the back of the mobo's i/o panel:

http://www.newegg.com/Product/Prod [...] _-11133184

Great case! NOW, I need the same PCI Express gen 2.0 with single lane(x1) throughput 5Gbit/s but with a actual USB 3.0 interface, so I don't need to route the cable out off the case.

...never ending...LOL!

Here’s the build, so far:

• ThermalTake A60 AMD Leo Edition
• Gigabyte 870A-USB3.0 mobo
• AMD Phenom ii x6 1100t – 6 Cores 3.3GHz
• 8 GB [for now] Crucial Ballistix DDR3 PC3-16000
• XFX Radeon HD 6870 1GB GDDR5
• Ultra LSP 750W Power Supply
• Kingston HyperX SSD 120GB Drive
• LG Blu-ray Disc Rewriter with LiteScribe
• Win 7 Ultimate 64 Bit.

Well, jakweeze the $20 item above will do the trick for my new case. Thanks for your help, and everyone else that had participated.

...you guys Rock!

Thanks for the Info about the SilverStone board!
That's what I Need also and have been searching everywhere.