Solder wont melt

hi there
i want to replace capacitors on motherboard for megaforce touchscreen, but the solder does not want to melt no matter how long I try. Any suggestions?
Thanks

What wattage of soldering iron do you use? I'm guessing that manufacturers using high wattage (very hot) with needle like tip to concentrate the heat better.

Careful though, too long on the soldering can damage other parts due to excessive heat build up.

As stated manufacturing solder is not the same as what you get from radio shack, it melts at a higher temp. Use a high watt iron that is fully heated then melt some solder on the tip and let that get hot a sec. you can then stick the ball of melted solder over what you are trying to de-solder. the melted solder gives a higher contact area than just touching one spot on the iron (similar to tinning wires before making a joint). the goal is to get the iron as hot as possible with the greatest area of contact possible while staying on the joint. If you do not, you will have the iron on it to long and damage the board itself or a nearby component. Just to be thorough, while you are heating the joint you should be pulling out from the other side with a pair of needle nose pliers

Some soldering irons need to heat for a good five minutes before melting anything. Some connections may require more than a few seconds of direct heat to melt. Make sure the tip of the soldering iron is closely and tinned.