[Solved] X58 and Marvell

So I just built my first system in 25 years and all works but......I have an error message in the system that says the "Marvell 91XX Config ATA Device" is not compatible with Win 7. The ASUS site does have a BETA driver update but from what I read on this site the general consensus is that Marvell is not very good. This is my system;

X58 MOB
i7-920
12GB's of Ram
WD Caviar Black 3GB 1TB Boot
Segate 1TB 6GB Drive
WD Green 1TB 3GB Drive

This is my question; Should I uninstall the Marvell Driver Software in windows and connect all the hard drives into the Intel 3GB connectors? If I do that do I need to do anything in the BIOS or will all connect via the Intel ICH10?

Thanks for your help

p.s. your site has been a big help for research and ideas!!!

1) Sata III only provides increase in burst performance for sata iii HDDs sustainded read/writes are NOT improved. You will see almost no differece between a SATA III HDD on Sata III port vs Sata II. SATA III SSDs currently are the only drives that benifit from Sata III. This will change as Hard Disk manuf start to incorporate a small SSD internally (functions like SRT in SB based systems. Segate has already come out (or will be) a 2.5 " HDD with an internal 8 gig SSD.

2) sounds more like a driver problem, than a Bios problem. Check manuf Website for there newest Marvel driver.

No and I think you can disable the marvel controller in Bios. You Did have it enabled - Just checking.

Best answer selected by azdogd1.