CT-7VIL3

I've had older motherboards that had a removable BIOS chip. On one particular MB, I had to remove the BIOS chip, send it to someone who had the device that could re-program it.

In the Chaintech CT-7VIL3 manual, there are only two remedies that I have available. The first is to do the process of resetting the CMOS jumper. I've tried this jumper resetting more times than I could count.

When the BIOS boots up, it stops at the POST 50 and just lists the CPU type/size. Hitting the Delete key will NOT work.

I've even replaced the keyboards thinking the DEL key stopped working.

I removed the battery and discovered the battery was dead. Replaced the battery and still no change.

I purchased a power supply tester thinking the PS was bad. Not true, the PS works fine.

I removed ALL the connections that connected ALL of the Hdwe. No change.

I even removed an old TV card and there was no change.

I changed the video card and no change.

I replaced the RAM chip and the replacement didn't make any change.

I do NOT understand your explanation of "Using the onboard chipset". As I understand, the video card is what produces the display.

The MB that I have does NOT have a video chip. That is why I have a separate AGP video card.

So, I don't understand your suggestion, "reconfigure your BIOS to read from GPU as default."

I must have a motherboard older than what you are familiar with.

You original post wasn't very clear and I misinterpreted your dilema. When you said you couldn't access the BIOS, I assumed you didn't have a display after clearing CMOS and/or removing the CMOS battery.

True, I didn't look up your motherboard because I wasn't feeling like searching if you didn't want post a link to it, but that's beside the point. My suggestion to use the motherboard video chipset was because of the misunderstanding of your post.
Seeing as you've already mentioned that you have no video chipset, and we're not discussing "no video"(again, my bad), then the suggestion is moot.

On with it...

So now I understand the problem is that POST freezes. Freezing is most commonly the result of overheating. Remove your heatsink and check the thermal paste, make sure there isn't too much(a pea size is good enough, but spread it out evenly) and then reseat your heatsink to make sure that it is on firmly and secured properly.

Other than overheating, you may have a bad motherboard.

Good luck.