I have the DFI Lanparty p35 and i have the
crucial ballistix tracers 2x1gb http://www.newegg.com/Product/Prod [...] 6820148076
mushkin 2x2gb http://www.newegg.com/Product/Prod [...] 6820146731

I realize that the speeds don;t matter but they have different voltages(crucial 2.2 and mushkin 1.8) so would i be able to run them in my board or should i just leave the mushkin in(btw i have 64-bit)

You most likely have to either leave bios on auto or set up ram to compromised settings. i.e. the speed of the slowest stick.

I wouldn't put them all in because of the different voltages. Your motherboard will probably land up putting 2.2 volts through all the chips and your 1.8volt chips are going to suffer.

Probably going to be a problem here. Your PC most likely will not boot, you'll have to manually set the voltages, and timings to the highest voltage required and the slowest timings of the 2 sets before you install the Crucial.
I wouldn't reccomend this combination personally.

It will work but is far from ideal. As others have said, you will have to juggle timings and voltages. It would be much better to get 2 sets with matching voltage and timings.

k ill stick with the 2x2gb and probably get another set. thanks guys

Yes it will run ! trust me . these noobs dont know what they are talking about. The Crucial Ballistix does not have to run at 2.2 v. That is only if you want to run it at 4-4-4-12 settings . Wich makes zero difference in FPS . I run my ballistix at 1.8v 5-5-5-15 wich is auto detect.


just use 5-5-5-15 and 1.8v on both sticks and youll be 100% fine. Theres is absolutely no difference in Fps even @ 3-3-4-10 timings wich the ballistix are able to run @ 2.1v . Ive never used my ballistix @ 2.2v because it works fine @ 1.8

I've never experienced this problem before, but I don't think too much damage could happen if you put in all 4 sticks onto your board (correct me if I'm wrong)