Categories:

High-Speed Hardware

High-Speed Hardware

Ad

The E6750’s low 8x maximum multiplier required a 520 MHz FSB to reach its maximum clock speed, in turn requiring a solid motherboard of similar capabilities. Gigabyte’s GA-P35T-QD6 was retained from our previous Extreme FSB overclocking article along with its F3c BIOS revision; F3i Beta is now available.

Overclocking is always about achieving the best performance, so fast RAM is a requirement. Super Talent’s DDR3-1600 is capable of speeds beyond 2000 MHz data rate, or latencies as low as CAS4, but not both at the same time. We’ll discuss our choice of speed versus latency for each overclock setting, following the CPU overclocking results.

With motherboard and DRAM limitations out of the way, processor cooling is the only major concern left. Heat is the greatest limiting factor in high-frequency stability, but higher voltages are also needed to keep signal strength up as frequencies are increased. Since any added voltage also increases heat, no amount of cooling is too much. Swiftech’s Apogee GTX LGA775 water block, triple 120 mm fan radiator, and MCP-655b water pump filled our needs.


Talkback
Leftfield42 09/08/2007 12:33
Hide
-0+
Leftfield42
Er, it might just be me, but where are the piccies??
blade85 09/08/2007 02:19
Hide
-0+
blade85
haha, i dont see them either
skyline0511 10/08/2007 10:08
Hide
-0+
skyline0511
Try disabling your adblock plus if ur using firefox. Others disable any ad blocker
Cabelo 10/08/2007 12:25
Hide
-0+
Cabelo
Can anyone still not see them? They seem to be alright now...
CJJE 15/08/2007 07:06
Hide
-0+
CJJE
Like many flight sim enthusiasts, I am trying to decide the most cost-effective CPU for FSX SP1. This can use multi-cores we're told but reports suggest not that well.

Could you add FSX SP1 (under Vista) to your benchmarks for CPUs please? I am particularly interested to know whether the E6850 is better than the Q6600 or not!

Note You are going to post a comment as anonymous.



Google Ads