Seagate 1TB Barracuda, Rated Good Health but High Read Error Rate & Seek Error Rate..

I recently switched to an old seagate 1tb barracuda HD after one of Western Digital Drives in my RAID 0 setup failed. I've run quite a few HD test's and they all say the drive is running fine (HDSentinel rates the drive at 100% health/performance & it pass seatools tests), but the read error rate seems very high to me. So i'm just wondering should i be concerned or is this normal drive behavior?

HD Tune Pro: ST31000528AS Health

ID Current Worst ThresholdData Status
(01) Raw Read Error Rate 117 99 6 130540314 ok
(03) Spin Up Time 96 95 0 0 ok
(04) Start/Stop Count 100 100 20 748 ok
(05) Reallocated Sector Count 100 100 36 0 ok
(07) Seek Error Rate 75 60 30 32030005 ok
(09) Power On Hours Count 93 93 0 6772 ok
(0A) Spin Retry Count 100 100 97 0 ok
(0C) Power Cycle Count 100 100 20 361 ok
(B7) SATA Downshift Count 100 100 0 0 ok
(B8) End To End Error Detection 100 100 99 0 ok
(BB) Uncorrectable Error Count 100 100 0 0 ok
(BC) Command Timeout 100 99 0 4295032833 ok
(BD) Unknown Attribute 100 100 0 0 ok
(BE) Airflow Temperature 62 50 45 639828006 ok
(C2) Temperature 38 50 0 94489280550 ok
(C3) Hardware ECC Recovered 54 28 0 130540314 ok
(C5) Current Pending Sector 100 100 0 0 ok
(C6) Offline Uncorrectable 100 100 0 0 ok
(C7) Interface CRC Error Count 200 200 0 0 ok
(F0) Head Flying Hours 100 253 0 152080496991579 ok
(F1) Unknown Attribute 100 253 0 -1438840723 ok
(F2) Unknown Attribute 100 253 0 -620496787 ok

Health Status : ok
1 answer Last reply
More about seagate 1tb barracuda rated good health high read error rate seek error rate
  1. bump*
Ask a new question

Read More

Western Digital Storage HD Health Seagate